Search results
Results from the WOW.Com Content Network
Initial configuration of the service as part of zero-touch or one-touch configuration process; Service re-establishment (ex. after device is factory-reset, exchanged) Remote subscriber support Verification of the device status and functionality; Manual reconfiguration; Firmware and configuration management Firmware upgrade/downgrade
Ubiquiti Inc. (formerly Ubiquiti Networks, Inc.) [3] is an American technology company founded in San Jose, California, in 2003. [ 1 ] [ 4 ] Now based in New York City , [ 5 ] Ubiquiti manufactures and sells wireless data communication and wired products for enterprises and homes under multiple brand names.
When a ZTP-enabled device is powered on, the device's boot file sets up configuration parameters. A switch then sends a request using DHCP or TFTP to get the device's configuration file from a central location. The file then runs and configures ports, IP addresses and other server parameters for each location. [2]
Radmind does not have higher-level configuration element (services, packages) abstraction. A graphical interface is available (only) for OS X. Rex Rex is a remote execution system with integrated configuration management and software deployment capabilities. The admin provides configuration instructions via so-called Rexfiles.
In addition, a compatibility switch feature [9] allows fine-grained interoperability adjustments. In an effort to avoid unnecessary load on hosts that do not participate in routing, RIPv2 multicasts the entire routing table to all adjacent routers at the address 224.0.0.9 , as opposed to RIPv1 which uses broadcast .
The standard provides configuration management and device management, allowing for configurations and firmware to be pushed to access points (APs). Because the overall state design of the CAPWAP protocol is largely the same as the finite-state machine (FSM) in LWAPP, a detailed diagram is not needed. [citation needed]
Extensible configuration of the entire hardware drivers, e.g. built-in network switches and their VLAN-capabilities, WNICs, DSL modems, FX, available hardware buttons, etc. Mesh networking through B.A.T.M.A.N., OLSR and IEEE 802.11s-capabilities of the WNIC drivers and other ad hoc mesh routing protocols that have been implemented within Linux.
The general convention is for network hubs, bridges and switches to use the MDI-X configuration, while all other nodes such as personal computers, workstations, servers and routers use an MDI interface. Some routers and other devices had an uplink/normal switch to go back and forth between MDI and MDI-X on a specific port. [1]