enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. F connector - Wikipedia

   en.wikipedia.org/wiki/F_connector

   The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable. The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold ...

3. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Generally use coaxial cable types such as RG-6 and RG-59 (except for twin-lead). Belling-Lee/IEC 169-2 connector TV aerial plug (a.k.a. antenna plug) Television antenna connection for most video devices outside North America. Used by early home computers and game consoles to connect them to TVs because of the lack of any other connector.

4. TV aerial plug - Wikipedia

   en.wikipedia.org/wiki/TV_aerial_plug

   A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.

5. Audio and video interfaces and connectors - Wikipedia

   en.wikipedia.org/wiki/Audio_and_video_interfaces...

   F connectors, also known as RF connectors, were the standard analog connector of the analog era in the Americas, used primarily with coaxial cable (RG-59 and RG-6), and have been repurposed for generic digital data connections. SCART was the standard connector of the analog era in Europe. S-Video was an improvement over the F connector.

6. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   The standard today is 75 ohm coaxial cable, which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on region) on the back of the TV. [6] To convert the signal from antennas that use a twin-lead line to the modern coaxial cable input, a small transformer called a balun is used in the line.

7. Optical fiber connector - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber_connector

   Angle-polished connectors should only be mated to other angle-polished connectors. The APC angle is normally 8 degrees, however, SC/APC also exists as 9 degrees in some countries. Mating to a non-angle polished connector causes very high insertion loss. Generally angle-polished connectors have higher insertion loss than good quality straight ...