Ads
related to: sae 2 bolt flange dimensions specifications
Search results
Results from the WOW.Com Content Network
The tolerances necessary to make the tools usable are listed in documents such as ASME/ANSI B18.2.2 for U.S. standards. [1] For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space.
ISO 68-2:1998: ISO general-purpose screw threads—Basic profile—Part 2: Inch screw threads: V Thread Form ISO 261:1998: ISO general purpose metric screw threads—General plan: V Thread Form: M6x1 ISO 262:1998: ISO general purpose metric screw threads—Selected sizes for screws, bolts and nuts: V Thread Form ISO 724:1993
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8 -24 thread [ 3 ] whereas an -6 AN fitting has a 9 ⁄ 16 -18 thread.
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut: Spring nut
Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice thread size (eg. M6 small series flange bolts have 8mm hexagonal heads, as would normally be found on M5 bolts). [10]
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
Ads
related to: sae 2 bolt flange dimensions specifications