Ad
related to: regenerative receiver
Search results
Results from the WOW.Com Content Network
A regenerative receiver, by contrast, could often provide adequate reception with the use of only one tube. In the 1930s the regenerative receiver was replaced by the superheterodyne circuit in commercial receivers due to the superheterodyne's superior performance and the falling cost of tubes.
It is a regenerative amplifier adjusted to provide positive feedback within the receiver. This has the effect of narrowing the receiver's bandwidth, as if the Q factor of its tuned circuits had been increased. The Q multiplier was a common accessory in shortwave receivers of the vacuum tube era as either a factory installation or an add-on ...
The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the gain of the receiver, positive feedback was used in its single RF amplifier stage; this also increased the selectivity of the receiver well beyond what would be expected from a single tuned circuit.
A foxhole radio is a simple crystal sets radio receiver cobbled together from whatever parts one could make (which were very few indeed) or scrounged from junked equipment. Such a set typically used salvaged domestic wiring for an antenna, a double-edged safety-razor blade and pencil lead (or bent safety-pin) for a detector, and a tin can ...
By the early 1930s National had established a reputation with the amateur radio community based upon their line of regenerative receivers, including the SW-3 and SW-5. National HRO receiver, circa 1938 Logo of National Company, late 1940s. In 1935 National introduced their top-of-the-line HRO receiver. This radio included two RF stages and a ...
English: Block diagram of a regenerative radio receiver, a type of radio receiver widely used before World War 2. It consists of a tuned circuit that serves as a bandpass filter to select the desired radio signal out of all the signals picked up by the antenna, and a combined amplifier-detector to increase the power of the signal and extract the audio modulation (sound) signal from from the ...
An audion receiver makes use of a single vacuum tube or transistor to detect and amplify signals. It is so called because it originally used the audion tube as the active element. Unlike a crystal detector or Fleming valve detector, the audion provided amplification of the signal as well as detection.
In the regenerative receiver the gain (amplification) of a vacuum tube or transistor is increased by using regeneration (positive feedback); some of the energy from the tube's output circuit is fed back into the input circuit with a feedback loop. [9] [89] [101] [102] [103] The early vacuum tubes had very low gain (around 5).
Ad
related to: regenerative receiver