Search results
Results from the WOW.Com Content Network
The MIL-STD-1168 is a set of standard codes used to identify munitions (ammunition, explosives and propellants). It was designed to replace the previous confusing Ammunition Identification Code (AIC) system used by the United States Army Ordnance Department.
- necked up to accept an 8mm bullet - The 8mm-06 allows owners of military surplus 7.92×57mm Mauser rifles to fire 8mm bullets using inexpensive, surplus 30-06 brass cases without rebarreling their rifle, only a rechambering is necessary. [16] Dimensions and performance are similar to the 8×64mm S cartridge.
A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches; BC: Ballistic coefficient, G1 model; L: Case length (mm)
The .30-06 Springfield cartridge case can hold 68.2 grains and has a volume of 4.42 millilitres (0.270 in 3). The exterior shape of the case was designed to promote reliable case feeding and extraction in bolt-action rifles and machine guns alike, under extreme conditions. [citation needed].30-06 Springfield maximum C.I.P. cartridge dimensions.
used to load the 173-grain (11.2 g) .30-06 Springfield M1 bullet; sold as military surplus by DCM [15] 1204 1925 1935 thin & short replaced by 4227 [15] 3031 1934 standard replaced 17 1/2; [18] for mid-range loads and medium sporting and military cartridges like the .257 Roberts, .30-30 and .348 Winchester [11] 4064 1935 standard
The .30 TC (0.308 in (7.8 mm) x 1.920 in (48.8 mm) is a non-magnum that is somewhat shorter and wider than the .308 and .30-06. [1] The .30 TC has speed and energy equal to the .30-06. [7] All three cartridges weigh approximately the same, but the .30 TC produces less recoil. The case length of the .30 TC is 1.92 inches. Although it is somewhat ...
The principle at work in the short magnum cartridge is the fitting of larger volumes of powder in closer proximity to the primer's flash hole, resulting in more-uniform ignition. .300 WSM has a case capacity of 80 grains. The .30-06 Springfield holds 69 grains; .308 Winchester holds 56 grains; 30-30 Winchester holds 45 grains.
The .30 Newton was high-velocity, rimless centerfire cartridge introduced in 1913. It was based on a German caliber of the period, the 11.2x72 Schuler. The cartridges were produced by the Western Cartridge Company. It was loaded with 150-gr (10 g) bullet, with a muzzle velocity of 3,208 ft/s (978 m/s), and 3,445 ft⋅lbf (4,671 J) of energy.