enow.com Web Search

  1. Ads

    related to: flat head m2.0 x 2.5mm 6

Search results

  1. Results from the WOW.Com Content Network
  2. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  3. Preferred metric sizes - Wikipedia

    en.wikipedia.org/wiki/Preferred_metric_sizes

    Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

  4. British Association screw threads - Wikipedia

    en.wikipedia.org/wiki/British_Association_screw...

    Thus, the shortening at the crest and root is given by 0.26817p with a radius of 0.18083p at both crest and root. [4]: 2 The 1884 report specifies a radius of ⁠ 2 / 11 ⁠ p ≈ 0.181818p but this was an approximation to the correct value. The pitch diameter of the thread is simply OD − 0.6p and the minor diameter is OD − 1.2p.

  5. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

  6. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).

  7. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    A Robertson screw, also known as a square screw [1] or Scrulox, [2] is a type of screw with a square-shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper .

  1. Ads

    related to: flat head m2.0 x 2.5mm 6