Search results
Results from the WOW.Com Content Network
Kentledge load testing in Haikou, Hainan, China. Static load testing is an in situ type of load testing used in geotechnical investigation to determine the bearing capacity of deep foundations prior to the construction of a building. It differs from the statnamic load test and dynamic load testing in that the pressure applied to the pile is slower.
On construction sites, prior to the erection of a building, static load testing may use a large number of kentledge stacked onto a platform. This platform is used to drive piles into the ground beneath to test the integrity of the foundation. [1] [2]
Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber piles, dynamic load testing can be done during installation or after installation. The procedure is standardized by ASTM D4945-00 Standard Test Method for High Strain Dynamic Testing of Piles.
Dynamic load testing takes a further step in analyzing the data and computing static capacity and resistance distribution. Dynamic pile monitoring takes advantage of the fact that, for driven piles, it is possible to compute the energy delivered to the pile, compression stresses at the pile top and toe and tension stresses along the shaft.
Pile integrity testing using low-strain tests such as the TDR (Transient Dynamic Response) method, is a rapid way of assessing the continuity and integrity of concrete piled foundations. The test measures: pile length, or depth to anomalies; pile head stiffness; pile shaft mobility, which is dependent on pile section and concrete properties
The Statnamic load test is a type of test for assessing the load-carrying capacity of deep foundations which is faster and less expensive than the static load test.The Statnamic test was conceived in 1985, with the first prototype tests carried out in 1988 through collaboration between Berminghammer Foundation Equipment of Canada and TNO Building Research of the Netherlands.
The commissioner of the New York Police Department said there are "no specific credible threats" to the New Year's Eve celebration in Times Square.
Franki piles can be installed raked (or sloped) with a tilt of up to 4:1. [5] Raked Franki piles are always reinforced and are particularly suitable for structures subject to dynamic forces. [1] Driving methods such as open-ended coring, rock socketing, and composite shaft construction are occasionally used to overcome unique site problems. [3]