Search results
Results from the WOW.Com Content Network
The decibel may be defined by the statement that two amounts of power differ by 1 decibel when they are in the ratio of 10 0.1 and any two amounts of power differ by N decibels when they are in the ratio of 10 N(0.1). The number of transmission units expressing the ratio of any two powers is therefore ten times the common logarithm of that ratio.
1 dB = 1 / 20 ln 10 is the decibel. The commonly used reference sound power in air is [11] = . The proper notations for sound power level using this reference are L W/(1 pW) or L W (re 1 pW), but the suffix notations dB SWL, dB(SWL), dBSWL, or dB SWL are very common, even if they are not accepted by the SI. [12]
1 B = 1 / 2 ln(10) is the bel; 1 dB = 1 / 20 ln(10) is the decibel. The commonly used reference sound intensity in air is [5] = /. being approximately the lowest sound intensity hearable by an undamaged human ear under room conditions.
A 10 dB increase in level is equivalent to a ten-fold increase in power. Therefore, a 20 dB increase in level is equivalent to a 100-fold increase in power. A 3 dB increase in level is approximately equivalent to doubling the power, which means that a level of 3 dBm corresponds roughly to a power of 2 mW.
The human auditory system is most sensitive to frequencies between 2,000 and 5,000 Hz. [10] Individual hearing range varies according to the general condition of a human's ears and nervous system. The range shrinks during life, [11] usually beginning at around the age of eight with the upper frequency limit being reduced. Women lose their ...
Ampex tape recorders in the 1950s achieved 60 dB in practical usage, [26] In the 1960s, improvements in tape formulation processes resulted in 7 dB greater range, [28]: 158 and Ray Dolby developed the Dolby A-Type noise reduction system that increased low- and mid-frequency dynamic range on magnetic tape by 10 dB, and high-frequency by 15 dB ...
The dynamic range is much larger than fixed-point but at a cost of a worse signal-to-noise ratio. This makes floating-point preferable in situations where the dynamic range is large or unpredictable. Fixed-point's simpler implementations can be used with no signal quality disadvantage in systems where dynamic range is less than 6.02m.
In engineering, attenuation is usually measured in units of decibels per unit length of medium (dB/cm, dB/km, etc.) and is represented by the attenuation coefficient of the medium in question. [1] Attenuation also occurs in earthquakes; when the seismic waves move farther away from the hypocenter, they grow smaller as they are attenuated by the ...