Search results
Results from the WOW.Com Content Network
Pressure-sensitive adhesive (PSA, self-adhesive, self-stick adhesive) is a type of nonreactive adhesive which forms a bond when pressure is applied to bond the adhesive with a surface. No solvent, water, or heat is needed to activate the adhesive. It is used in pressure-sensitive tapes, labels, glue dots, stickers, sticky note pads, automobile ...
Pressure-sensitive tape or pressure-sensitive adhesive tape (PSA tape) is an adhesive tape that sticks when pressure is applied without the need for a solvent (such as water) or heat for activation. It is also known in various countries as self-stick tape , sticky tape , or just adhesive tape and tape , as well as genericized trademarks , such ...
Adhesive removers are intended to break down glue so that it can be removed from surfaces easily. [1] [2] [3] Formulations may be designed to remove a broad range of adhesives or to address a specific bond. [1] Many general purpose removers are intended to remove residue from adhesive tape. [1] [2] [3]
A typical PSA tape consists of a pressure-sensitive adhesive (the sticky part of the tape) coated to a backing material. To prevent the adhesive from sticking to the backing when wound in a roll, a release agent is applied to the backing or a release liner is placed on the adhesive. Sometimes a primer is coated between the adhesive and backing ...
It is sticky (tacky) without any heat or solvent for activation and adheres to surfaces with light pressure. Typical adhesives are polymers such as acrylates, natural, and synthetic rubber. These tapes usually require a release agent on their backing or a release liner to cover the adhesive. Sometimes, the term "adhesive tape" is used for these ...
Later these kinds of adhesives were used in cloth backed surgical and electric tapes. By 1925, the pressure-sensitive tape industry was born. [3] Today, sticky notes, Scotch Tape, and other tapes are examples of pressure-sensitive adhesives (PSA). [21]
The bonding temperature is lower than with most other HMAs, only about 50 °C (122 °F) to 70 °C (158 °F), when the adhesive behaves as a soft rubber acting as a pressure-sensitive adhesive. The surface wetting in this amorphous state is good, and on cooling the polymer crystallizes, forming a strong flexible bond with high cohesion.
An electrically conductive adhesive is a glue that is primarily used for electronics. The electric conductivity is caused by a component that makes ca. 80% of the total mass of an electrically conductive adhesive. This conductive component is suspended in a sticky component that holds the electrically conductive adhesive together.