Search results
Results from the WOW.Com Content Network
This prototype utilized an SiC emitter operating at 1250 °C and GaSb photocells and was approximately 0.5 m tall. [33] The power source had an efficiency of 2.5%, calculated as the ratio of the power generated to the thermal energy of the fuel burned. This is too low for practical battlefield use.
Most air conditioners have a COP of 2.3 to 3.5. [4] When talking about the efficiency of heat engines and power stations the convention should be stated, i.e., HHV (a.k.a. Gross Heating Value, etc.) or LCV (a.k.a. Net Heating value), and whether gross output (at the generator terminals) or net output (at the power station fence) are being ...
To express the efficiency of a generator or power plant as a percentage, invert the value if dimensionless notation or same unit are used. For example: A heat rate value of 5 gives an efficiency factor of 20%. A heat rate value of 2 kWh/kWh gives an efficiency factor of 50%. A heat rate value of 4 MJ/MJ gives an efficiency factor of 25%.
Thermal conduction rate, thermal current, thermal/heat flux, thermal power transfer P = / W ML 2 T −3: Thermal intensity I = / W⋅m −2: MT −3: Thermal/heat flux density (vector analogue of thermal intensity above) q
The heat pump itself can be improved by increasing the size of the internal heat exchangers, which in turn increases the efficiency (and the cost) relative to the power of the compressor, and also by reducing the system's internal temperature gap over the compressor. Obviously, this latter measure makes some heat pumps unsuitable to produce ...
An electronic amplifier that delivers 10 watts of power to its load (e.g., a loudspeaker), while drawing 20 watts of power from a power source is 50% efficient. (10/20 × 100 = 50%) Electric kettle: more than 90% [citation needed] (comparatively little heat energy is lost during the 2 to 3 minutes a kettle takes to boil water).
Although it is named "power usage effectiveness", it actually measures the energy use of the data centre. [10] The PUE metric has several important benefits. First, the calculation can be repeated over time, allowing a company to view their efficiency changes historically, or during time-limited events like seasonal changes.
This efficiency limit of ~34% can be exceeded by multijunction solar cells. If one has a source of heat at temperature T s and cooler heat sink at temperature T c, the maximum theoretically possible value for the ratio of work (or electric power) obtained to heat supplied is 1-T c /T s, given by a Carnot heat engine. If we take 6000 K for the ...