Search results
Results from the WOW.Com Content Network
It was an industry de facto standard for many years, and was finally standardized as IEEE 1284 in the late 1990s, which defined the Enhanced Parallel Port (EPP) and Extended Capability Port (ECP) bi-directional versions. Today, the parallel port interface is virtually non-existent in new computers because of the rise of Universal Serial Bus ...
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
Parallel versus serial communication In data transmission , parallel communication is a method of conveying multiple binary digits ( bits ) simultaneously using multiple conductors. This contrasts with serial communication , which conveys only a single bit at a time; this distinction is one way of characterizing a communications link .
In general, parallel interfaces are quoted in B/s and serial in bit/s. The more commonly used is shown below in bold type. On devices like modems , bytes may be more than 8 bits long because they may be individually padded out with additional start and stop bits; the figures below will reflect this.
The (TCP) and the (UDP) only need one for , bidirectional traffic. They usually use port numbers that match the services of the corresponding TCP or UDP implementation, if they exist. The Internet Assigned Numbers Authority (IANA) is responsible for maintaining the official assignments of port numbers for specific uses, [ 1 ] However, many ...
For example, a USB-to-parallel-port converter might work well with a printer, but not with a scanner that requires bidirectional use of the data pins. For a product developer, using USB requires the implementation of a complex protocol and implies an "intelligent" controller in the peripheral device.
A parallel slave port (PSP) is an interface found on some PIC microcontrollers. [1] It allows 8-bit asynchronous bidirectional data transfer between the PIC and external devices, such as other microcontrollers or personal computers. [2]
For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port. Some personal computers put non-standard voltages or signals on some pins of their serial ports.