Search results
Results from the WOW.Com Content Network
the bend angle of the joint, or angle of the axles with respect to each other, with zero being parallel or straight through. These variables are illustrated in the diagram on the right. Also shown are a set of fixed coordinate axes with unit vectors x ^ {\displaystyle {\hat {\mathbf {x} }}} and y ^ {\displaystyle {\hat {\mathbf {y} }}} and the ...
It is normally a ball and cage type with an inner race splined to the intermediate shaft. An outer race is formed in the yoke. The cage retains the balls in location in grooves in both races. The balls transfer the drive from the shaft to the hub and allow for changes in horizontal angle and for a wide steering angle to be achieved.
A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
A split shaft PTO is mounted to the truck's drive shaft to provide power to the PTO. Such a unit is an additional gearbox that separates the vehicle's drive shaft into two parts: The gearbox-facing shaft which will transmit the power of the engine to the split shaft PTO; The axle-facing shaft which transmit the propelling power to the axle.
Pressure angles. Pressure angle in relation to gear teeth, also known as the angle of obliquity, [1] is the angle between the tooth face and the gear wheel tangent. It is more precisely the angle at a pitch point between the line of pressure (which is normal to the tooth surface) and the plane tangent to the pitch surface.
In addition to transmitting traction forces, the torque tube is hollow and contains the rotating driveshaft. Inside the hollow torque ball is the driveshaft's universal joint that allows relative motion between the two ends of the driveshaft. In most applications, the drive shaft uses a single universal joint, which has the disadvantage that it ...
Before shaft alignment can be done, the foundations for the driver and the driven piece must be designed and installed correctly. [citation needed]Flexible couplings are designed to allow a driver (e.g., electric motor, engine, turbine, hydraulic motor) to be connected to the driven equipment.