Search results
Results from the WOW.Com Content Network
With normal bullet weights between 300 and 400 grains (19 and 26 g), overall cartridge length shorter than that of an AR-15 magazine well, and holding to pressures of 33,000 psi limited by the AR bolt strength system, [2] the .50 Beowulf is best described as a low-velocity, heavy caliber, making its ballistics roughly equivalent to those of ...
However, the 50 Beowulf case is longer than the 50AE, so the 50AE cases cannot be used as a donor. Note about donor cases: The 7.62x51 military cartridge the civilian version is the .308 cartridge. Since its dimensions are taken from the 30-06 cartridge from the 1906 US Army cartridge, the lower half of these case dimensions have been used for ...
The AR Lower V5 is a 3D printed lower receiver for the AR-15 rifle. [1] It was created in March 2013 Defense Distributed printed using the Stratasys Dimension SST 3-D printer [1] [2] using the fused deposition modeling (FDM) method. [2] The receiver was able to handle enough stress to fire more than 600 rounds. [1]
ArmaLite AR-15 with the charging handle located on top of the upper receiver, protected within the carrying handle and a 25-round magazine. 1973 Colt AR-15 SP1 rifle with "slab side" lower receiver (lacking raised boss around magazine release button) and original Colt 20-round magazine.
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
The Close Quarter Battle Receiver (CQBR) [5] is a replacement upper receiver for the M4A1 carbine developed by the US Navy.. The CQBR features a 10.3 in (262 mm) length barrel (similar to the Colt Commando short-barreled M16 variants of the past) which makes the weapon significantly more compact, thus making it easier to use in, and around, vehicles and in tight, confined spaces.
The receiver is made from two parts (upper and lower), stamped from sheet steel and connected by cross-pins. The heavy barrel is fluted to improve heat dissipation and save weight, and fitted with a large and effective reactive muzzle brake. The muzzle brakes on the earlier models had a round cross-section; later M82 rifles are equipped with ...
A Special Purpose Receiver built by NWSC Crane Division, mounted on an M16A1 lower receiver The SOPMOD program also introduced the Special Purpose Receiver (SPR), a 16-or-18 in (406-or-457 mm) barreled upper receiver that would be mated to an M4A1 lower receiver to allow the weapon to serve as a designated marksman rifle (DMR).