Search results
Results from the WOW.Com Content Network
Tube flaring is a type of forging operation, [1] and is usually a cold working procedure. During assembly, a flare nut is used to secure the flared tubing's tapered end to the also tapered fitting, producing a pressure-resistant, leak-tight seal. Flared connections offer a high degree of long-term reliability and for this reason are often used ...
Engineer's blue is prepared by mixing Prussian blue with a non-drying oily material (for example, grease).The coloured oil is rubbed onto a reference surface, and the workpiece is then rubbed against the coloured reference; the transfer (by contact) of the pigment indicates the position of high spots on the workpiece or conversely highlight low points. [1]
In tube hydroforming there are two major practices: high pressure and low pressure. With the high pressure process the tube is fully enclosed in a die prior to pressurization of the tube. In low pressure the tube is slightly pressurized to a fixed volume during the closing of the die (this used to be called the Variform process).
Bluing, sometimes spelled as blueing, is a passivation process in which steel is partially protected against rust using a black oxide coating. It is named after the blue-black appearance of the resulting protective finish.
An induction coil is placed around a small section of the pipe at the bend point. It is then induction heated to between 800 and 2,200 degrees Fahrenheit (430 and 1,200 C). While the pipe is hot, pressure is placed on the pipe to bend it. The pipe can then be quenched with either air or water spray or be cooled against ambient air.
A 7 + 5 ⁄ 8 in (190 mm) production casing is set at a depth of about 15,000 ft (4,600 m) and a 5 in (130 mm) production liner set to TD. Probably, this well required a high mud weight at the bottom of the hole and cementing the 7 + 5 ⁄ 8 in (190 mm) casing at TD would have resulted in too much pressure and lost circulation. If lost ...
Unlike coiled tubing or wireline, where the wire or tubing is always the same diameter allowing for a single unmoving primary barrier (stuffing box or stripper), snubbing uses a pipe, which will have an enlarged collar at the connection between the joints. Therefore, the pressure control system must be able to accommodate this variable diameter.
While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...