Ads
related to: dodge front end parts
Search results
Results from the WOW.Com Content Network
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60.
Dodge pioneered the extended-cab pickup with the introduction of the Club Cab for 1973. Available with either a 6.5 ft (2.0 m) or 8 ft (2.4 m) Sweptline bed, the Club Cab was a two-door cab with small rear windows which had more space behind the seats than the standard cab, but was not as long as the four-door crew cab.
Fascia was adopted then as the term to describe these soft areas, [4] but is now increasingly used as a general term for a car's set of front-end components: grille, headlamps, front bumper, and other details.
The Dodge Regent is an automobile that was built by Dodge Canada.The low-priced line built with a front end similar to the U.S. market Dodge attached to a Plymouth body.. The first Dodge Regent appeared for 1951, basically a Plymouth Cranbrook, and replaced the Special DeLuxe name used from 1942 through 1950.
The special Rallye suspension used heavy-duty parts and increased the rate of the rear springs. The T/A was one of the first U.S. muscle cars to fit different size tires at the front and rear: E60x15 Goodyear Polyglas in the front, and G60x15 on the rear axle.
Ads
related to: dodge front end parts