enow.com Web Search

  1. Ad

    related to: what is impedance matching in ear measurement tool

Search results

  1. Results from the WOW.Com Content Network
  2. Impedance matching - Wikipedia

    en.wikipedia.org/wiki/Impedance_matching

    In electrical engineering, impedance matching is the practice of designing or adjusting the input impedance or output impedance of an electrical device for a desired value. Often, the desired value is selected to maximize power transfer or minimize signal reflection .

  3. Immittance - Wikipedia

    en.wikipedia.org/wiki/Immittance

    Immittance is a term used within electrical engineering and acoustics, specifically bioacoustics and the inner ear, to describe the combined measure of electrical or acoustic admittance and electrical or acoustic impedance.

  4. Audio system measurements - Wikipedia

    en.wikipedia.org/wiki/Audio_system_measurements

    The measurement is given in % and a lower number is better. Rumble The measure of the low frequency (many tens of Hz) noise contributed by the turntable of an analogue playback system. It is caused by imperfect bearings, uneven motor windings, vibrations in driving bands in some turntables, room vibrations (e.g., from traffic) that is ...

  5. Middle ear - Wikipedia

    en.wikipedia.org/wiki/Middle_ear

    The middle ear matches mechanical impedance, like a lever. Ordinarily, when sound waves in air strike liquid, most of the energy is reflected off the surface of the liquid. The middle ear allows the impedance matching of sound traveling in air to acoustic waves traveling in a system of fluids and membranes in the inner ear. This system should ...

  6. Mismatch loss - Wikipedia

    en.wikipedia.org/wiki/Mismatch_loss

    Mismatch loss in transmission line theory is the amount of power expressed in decibels that will not be available on the output due to impedance mismatches and signal reflections. A transmission line that is properly terminated, that is, terminated with the same impedance as that of the characteristic impedance of the transmission line, will ...

  7. Hearing - Wikipedia

    en.wikipedia.org/wiki/Hearing

    The purpose of the middle ear ossicles is to overcome the impedance mismatch between air waves and cochlear waves, by providing impedance matching. Also located in the middle ear are the stapedius muscle and tensor tympani muscle , which protect the hearing mechanism through a stiffening reflex.

  8. Standing wave ratio - Wikipedia

    en.wikipedia.org/wiki/Standing_wave_ratio

    In radio engineering and telecommunications, standing wave ratio (SWR) is a measure of impedance matching of loads to the characteristic impedance of a transmission line or waveguide. Impedance mismatches result in standing waves along the transmission line, and SWR is defined as the ratio of the partial standing wave 's amplitude at an ...

  9. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  1. Ad

    related to: what is impedance matching in ear measurement tool