enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF modulator - Wikipedia

   en.wikipedia.org/wiki/RF_modulator

   The modulator is then programmed to broadcast the signals on a certain frequency. That RF broadcast is then received by the connected TV. When the TV is tuned to the programmed channel, the video and audio signal of the source device is accessed. RF modulation can become difficult in a CATV system. High pass, low pass, and notch filters must be ...

3. Sup'R'Mod - Wikipedia

   en.wikipedia.org/wiki/Sup'R'Mod

   Composite video is received by the circuit board through a short cable terminating in a Molex connector, which plugs into a header on the Apple II motherboard. Input can also be provided through an RCA connector. The output of the RF modulator goes out through a coaxial cable to the antenna switch. [5] [6]

4. 8VSB - Wikipedia

   en.wikipedia.org/wiki/8VSB

   ATSC and DVB-T specify the modulation used for over-the-air digital television; by comparison, QAM is the modulation method used for cable. The specifications for a cable-ready television, then, might state that it supports 8VSB (for broadcast TV) and QAM (for cable TV). 8VSB is an 8-level vestigial sideband modulation.

5. Tuner (radio) - Wikipedia

   en.wikipedia.org/wiki/Tuner_(radio)

   Cable boxes, converter boxes and other set top boxes contain tuners for digital TV services, and send their output via SCART or other connector, or using an RF modulator (typically on channel 36 in Europe and channel 3/4 in North America) to TV receivers that do not natively support the services.

6. QAM (television) - Wikipedia

   en.wikipedia.org/wiki/QAM_(television)

   QAM is used in a variety of communications systems such as Dial-up modems and WiFi. In cable systems, a QAM tuner is linked to the cable in a manner that is equivalent to an ATSC tuner which is required to receive over-the-air (OTA) digital channels broadcast by local television stations when attached to an antenna. Most new HDTV digital ...

7. Video modulation - Wikipedia

   en.wikipedia.org/wiki/Video_modulation

   Video signals are usually encoded into binary digit (0, 1) or seven digit pulse-code modulation (PCM), which is a method used to digitally represent original video signal. . The video signal converted to binary digit PCM at the point of origin can be then transmitted over existing telephone cable or wire directly to the destination