Search results
Results from the WOW.Com Content Network
For an injection well, the target is selected to locate the point of injection in a permeable zone that may support disposing of water or gas and/or pushing hydrocarbons into nearby production wells. The target (the endpoint of the well) will be matched with a surface location (the starting point of the well), and a trajectory between the two ...
Another factor in the selection of specific completion equipment is the production rates of the well. The typical job duties of a Subsurface engineer include managing the interface between the reservoir and the well, including perforations, sand control, artificial lift, downhole flow control, and downhole monitoring equipment.
Well completion is the process of making a well ready for production (or injection) after drilling operations. This principally involves preparing the bottom of the hole to the required specifications, running in the production tubing and its associated down hole tools as well as perforating and stimulating as required.
Petroleum production engineering is a subset of petroleum engineering. Petroleum production engineers design and select subsurface equipment to produce oil and gas well fluids . [ 1 ] They often are degreed as petroleum engineers , although they may come from other technical disciplines (e.g., mechanical engineering , chemical engineering ...
Petroleum engineering is a field of engineering concerned with the activities related to the production of hydrocarbons, which can be either crude oil or natural gas. [1] Exploration and production are deemed to fall within the upstream sector of the oil and gas industry.
Well stimulation is a broad term used to describe the various techniques and well interventions that can be used to restore or enhance the production of hydrocarbons from an oil well. Hydraulic fracturing (fracking) and acidizing are two of the most common methods for well stimulation.
Derrick (#14) is the support structure for the equipment used to lower and raise the drill string into and out of the wellbore. This consists of the sub-structure (structure below the drill floor level) and the mast. Desander / desilter (not pictured) contains a set of hydrocyclones that separate sand and silt from the drilling fluid. Typically ...
A production separator is used to separate the produced well fluid from a well, group of wells, or a lease on a daily or continuous basis. Production separators can be vertical, horizontal, or spherical. They can be two-phase or three-phase. Production separators range in size from 12 in. to 15 ft in diameter, with most units ranging from 30 in ...