Ads
related to: pull up resistor high
Search results
Results from the WOW.Com Content Network
A resistor with relatively high resistance is called a "weak" pull-up or pull-down; when the circuit is open, it will pull the output high or low more slowly, but will draw less current. This current, which is essentially wasted energy, only flows when the switch is closed, and technically for a brief period after it is opened until the charge ...
Higher operating speeds require lower resistor values for faster pull-up, which consume even more power. Also when driving a load, current through the pull-up resistor reduces the output high voltage by a voltage drop equal to the current times resistance, according to Ohm's law.
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.
Between data frames, the bus controller holds SCL high, in effect stopping the clock, and SDA drivers are in a high-impedance state, permitting a pull-up resistor to float it to high. A high-to-low transition of SDA while SCL is high is known as a START symbol, and signals the beginning a new data frame.
The high-impedance state of a given node in a circuit cannot be verified by a voltage measurement alone. A pull-up resistor (or pull-down resistor) can be used as a medium-impedance source to try to pull the wire to a high (or low) voltage level. If the node is not in a high-impedance state, extra current from the resistor will not ...
Circuit designers will often use pull-up or pull-down resistors (usually within the range of 1–100 kΩ) to influence the circuit when the output is tri-stated. The PCI local bus provides pull-up resistors, but they would require several clock cycles to pull a signal high given the bus's large distributed capacitance .
Ads
related to: pull up resistor high