Search results
Results from the WOW.Com Content Network
In computer graphics, a video card's pixel fillrate refers to the number of pixels that can be rendered on the screen and written to video memory in one second. [1] Pixel fillrates are given in megapixels per second or in gigapixels per second (in the case of newer cards), and are obtained by multiplying the number of render output units (ROPs) by the clock frequency of the graphics processing ...
The clock rate of the first generation of computers was measured in hertz or kilohertz (kHz), the first personal computers (PCs) to arrive throughout the 1970s and 1980s had clock rates measured in megahertz (MHz), and in the 21st century the speed of modern CPUs is commonly advertised in gigahertz (GHz).
The Kepler line of graphics cards by Nvidia were released in 2012 and were used in the Nvidia's 600 and 700 series cards. A feature in this GPU microarchitecture included GPU boost, a technology that adjusts the clock-speed of a video card to increase or decrease it according to its power draw. [42]
Core clock – The reference base and boost (if available) core clock frequency. Fillrate. Pixel - The rate at which pixels can be rendered by the raster operators to a display. Measured in pixels/s. Texture - The rate at which textures can be mapped by the texture mapping units onto a polygon mesh. Measured in texels/s. Performance
The GPU is always guaranteed to run at a minimum clock speed, referred to as the "base clock". This clock speed is set to the level which will ensure that the GPU stays within TDP specifications, even at maximum loads. [3] When loads are lower, however, there is room for the clock speed to be increased without exceeding the TDP.
RDNA 3 was designed to support high clock speeds. On RDNA 3, clock speeds have been decoupled with the front end operating at a 2.5 GHz frequency while the shaders operate at 2.3 GHz. The shaders operating at a lower clock speed gives up to 25% power savings according to AMD and RDNA 3's shader clock speed is still 15% faster than RDNA 2. [19]
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
The processor consists of different clock domains, meaning that the entire chip does not operate the same clock speed. This causes some difficulty when measuring peak throughput of its various functions. Further adding to the confusion, it is listed as 667 MHz in Intel G965 white paper, but listed as 400 MHz in Intel G965 datasheet.