Search results
Results from the WOW.Com Content Network
ifconfig (short for interface config) is a system administration utility in Unix-like operating systems for network interface configuration. The utility is a command-line interface tool and is also used in the system startup scripts of many operating systems. It has features for configuring, controlling, and querying TCP/IP network interface ...
The ipconfig command supports the command-line switch /all. This results in more detailed information than ipconfig alone. An important additional feature of ipconfig is to force refreshing of the DHCP IP address of the host computer to request a different IP address. This is done using two commands in sequence.
Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...
The configuration software of choice is then used to configure the persistent configuration which is applied on boot. It is also possible to configure Linux networking ad-hoc using the ip command from the iproute2 package. The following command can be used to configure the route using ip: [10]
IP addresses are assigned to a host either dynamically as they join the network, or persistently by configuration of the host hardware or software. Persistent configuration is also known as using a static IP address. In contrast, when a computer's IP address is assigned each time it restarts, this is known as using a dynamic IP address.
The client's IP address, subnet mask, and default gateway address. The IP address and host name of the BOOTP server. The IP address of the server that has the boot image, which the client needs to load its operating system. When the client receives this information from the BOOTP server, it configures and initializes its TCP/IP protocol stack ...
Most network address translators map multiple private hosts to one publicly exposed IP address. Here is a typical configuration: A local network uses one of the designated private IP address subnets (RFC 1918 [4]). The network has a router having both a private and a public address.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router