enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   A punch down tool, punchdown tool, IDC tool, or a Krone tool (named after the Krone LSA-PLUS connector), is a small hand tool used by telecommunication and network technicians. It is used for inserting wire into insulation-displacement connectors on punch down blocks , patch panels , keystone modules , and surface mount boxes (also known as ...

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

4. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...

5. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

6. Punch-down block - Wikipedia

   en.wikipedia.org/wiki/Punch-down_block

   A split-50 M-type 66 block with bridging clips attached A 110 punch-down block. A punch-down block (also punchdown block, punch block, punchblock, quick-connect block and other variations) is a type of electrical connection often used in telephony.

7. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   Crimp tool for 0.14 mm 2 to 10 mm 2 (26–8 AWG) insulated and non-insulated ferrules. Crimping is a method of joining two or more pieces of metal or other ductile material by deforming one or both of them to hold the other.