enow.com Web Search

  1. Ads

    related to: semi-rigid coaxial cable

Search results

  1. Results from the WOW.Com Content Network
  2. Coaxial cable - Wikipedia

    en.wikipedia.org/wiki/Coaxial_cable

    Semi-rigid coax assembly Semi-rigid coax installed in an Agilent N9344C 20GHz spectrum analyser. Semi-rigid cable is a coaxial form using a solid copper outer sheath. This type of coax offers superior screening compared to cables with a braided outer conductor, especially at higher frequencies.

  3. List of RF connector types - Wikipedia

    en.wikipedia.org/wiki/List_of_RF_connector_types

    A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

  4. EIA RF Connectors - Wikipedia

    en.wikipedia.org/wiki/EIA_RF_Connectors

    The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.

  5. Copper conductor - Wikipedia

    en.wikipedia.org/wiki/Copper_conductor

    Semi-rigid coaxial cable for microwave transmission. While coaxial cables can go longer distances and have better protection from EMI than twisted pairs, coaxial cables are harder to work with and more difficult to run from offices to the wiring closet.

  6. RG-59 - Wikipedia

    en.wikipedia.org/wiki/RG-59

    RG-59 coaxial cable is commonly packed with consumer equipment, such as VCRs or digital cable/satellite receivers. Manufacturers tend to include only RG-59 cables because it costs less than RG-6 does. However, given the short lengths provided (usually 4–6 ft or 1.2–1.8 m), this is generally sufficient for its typical use.

  7. SMA connector - Wikipedia

    en.wikipedia.org/wiki/SMA_connector

    The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.

  1. Ads

    related to: semi-rigid coaxial cable