enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   The tapered key is tapered only on the side that engages the hub. The keyway in the hub has a taper that matches that of the tapered key. Some taper keys have a gib, or tab, for easy removal during disassembly. The purpose of the taper is to secure the key itself, as well as to firmly engage the shaft to the hub without the need for a set screw.

3. List of ISO standards 1–1999 - Wikipedia

   en.wikipedia.org/wiki/List_of_ISO_standards_1–1999

   ISO 1080:1975 Machine tools — Morse taper shanks — Cotter slots with taper keys; ISO 1081:2013 Belt drives – V-belts and V-ribbed belts, and corresponding grooved pulleys – Vocabulary; ISO 1082:1990 Mining — Shackle type connector units for chain conveyors; ISO 1083:2018 Spheroidal graphite cast irons — Classification

4. Coupling - Wikipedia

   en.wikipedia.org/wiki/Coupling

   A tapered lock is a form of keyless shaft locking device [6] that does not require any material to be removed from the shaft. The basic idea is similar to a clamp coupling but the moment of rotation is closer to the center of the shaft. [ 7 ]

5. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.

6. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

7. Taper pin - Wikipedia

   en.wikipedia.org/wiki/Taper_pin

   A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.