enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Axle - Wikipedia

   en.wikipedia.org/wiki/Axle

   The overall assembly can carry more weight than a semi-floating or non-floating axle assembly because the hubs have two bearings riding on a fixed spindle. A full-floating axle can be identified by a protruding hub to which the axle shaft flange is bolted. The semi-floating axle setup is commonly used on half-ton and lighter 4×4 trucks in the ...

3. Wheel hub assembly - Wikipedia

   en.wikipedia.org/wiki/Wheel_hub_assembly

   The hub assembly is located between the brake drums or discs and the drive axle. A wheel is bolted on it. Depending on the construction, the end of the hub comes equipped with the splined teeth. They mate the teeth on the axle shaft. The axle hub spins along with the wheels bolted to it and provide power to the wheels in order to rotate.

4. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   Wheel hub with disc brake and 5 wheel studs. Wheel studs are the threaded fasteners that hold on the wheels of many automobiles. They are semi-permanently mounted directly to the vehicle hub, usually through the brake drum or brake disk. Lug nuts are fastened onto the wheel stud to secure the wheel. When a wheel is removed for tire changes etc ...

5. Steering knuckle - Wikipedia

   en.wikipedia.org/wiki/Steering_knuckle

   In a drive suspension, the knuckle has no spindle, but rather has a hub into which is affixed the bearings and shaft of the drive mechanism. The end of the drive mechanism would then have the necessary mounting studs for the wheel/tire and/or brake assembly. Therefore, the wheel assembly would rotate as the drive shaft (or half-shaft) dictates.

6. Trunnion - Wikipedia

   en.wikipedia.org/wiki/Trunnion

   In older cars, the trunnion is part of the suspension and either allows free movement of the rear wheel hub in relation to the chassis [10] or allows the front wheel hub to rotate with the steering. On many cars (such as those made by Triumph [ 11 ] ) the trunnion is machined from a brass or bronze casting and is prone to failure if not greased ...

7. Centerlock wheel - Wikipedia

   en.wikipedia.org/wiki/Centerlock_wheel

   These consist of a shaft at the hub, with an external screw thread, a straight external spline section and a tapered interface at the hub base. The wheel centers have internal splines and a matching taper to align and center them on the hub. The wheels are fastened to the hub by means of a winged, threaded nut, called a "knock-off" or "spinner."