Search results
Results from the WOW.Com Content Network
10 nanoseconds, also a casual term for a short period of time. microsecond: 10 −6 s: One millionth of a second. Symbol is μs millisecond: 10 −3 s: One thousandth of a second. Shortest time unit used on stopwatches. jiffy (electronics) ~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short ...
10 −3: millisecond: ms One thousandth of one second 1 ms: The time for a neuron in the human brain to fire one impulse and return to rest [13] 4–8 ms: The typical seek time for a computer hard disk: 10 −2: centisecond cs One hundredth of one second 1.6667 cs: The period of a frame at a frame rate of 60 Hz. 2 cs: The cycle time for ...
10 milliseconds (10 ms) – a jiffy, cycle time for frequency 100 Hz; 10.378 milliseconds – rotation period of pulsar B1639+36A; 15.625 milliseconds – a two hundred fifty-sixth note at 60 BPM; 16.67 milliseconds (1/60 second) – a third, cycle time for American 60 Hz AC electricity (mains grid) 16.68 milliseconds (1/59.94 second) – the ...
1 microsecond – the length of time of a high-speed, commercial strobe light flash (see air-gap flash). 1 microsecond – protein folding takes place on the order of microseconds (thus this is the speed of carbon-based life). 1.8 microseconds – the amount of time subtracted from the Earth's day as a result of the 2011 Japanese earthquake. [1]
Metric time is the measure of time intervals using the metric system. The modern SI system defines the second as the base unit of time, and forms multiples and submultiples with metric prefixes such as kiloseconds and milliseconds. Other units of time – minute, hour, and day – are accepted for use with SI, but are not part of it
A nanosecond (ns) is a unit of time in the International System of Units (SI) equal to one billionth of a second, that is, 1 / 1 000 000 000 of a second, or 10 −9 seconds. The term combines the SI prefix nano- indicating a 1 billionth submultiple of an SI unit (e.g. nanogram, nanometre , etc.) and second , the primary unit of time in ...
The round-trip time or ping time is the time from the start of the transmission from the sending node until a response (for example an ACK packet or ping ICMP response) is received at the same node. It is affected by packet delivery time as well as the data processing delay , which depends on the load on the responding node.
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...