enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. LED tube - Wikipedia

   en.wikipedia.org/wiki/LED_tube

   LED tubes. LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life. LED tubes are sometimes also referred to as ‘LED fluorescent tubes’.

3. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   Retrofit replacement for 45.8 in T5HO 54 W T8 1.0, 25 4 25 F32T8/25w Retrofit replacement for 4 ft T8 32 W T8 1.0, 25 4 28 F28T8 F32T8/28w Retrofit replacement for 4 ft T8 32 W T8 1.0, 25 4 30 F32T8/ES Retrofit replacement for 4 ft T8 32 W T8: 1.0, 25: 2: 17 F17T8: Ballast-swap replacement for 2 ft T12 20 W T8 1.0, 25 3 25 F25T8

4. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

5. Wedge base - Wikipedia

   en.wikipedia.org/wiki/Wedge_base

   Bulbs of this type are commonly used in automotive lighting and in low-voltage lighting used in landscape lighting. The bulb may have dual filaments, acting as both a low-wattage tail light or parking light and a higher-wattage brake light or turn signal. In this case, one has its contacts near the center of the base, and the other toward the ...

6. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

7. Knob-and-tube wiring - Wikipedia

   en.wikipedia.org/wiki/Knob-and-tube_wiring

   When a generic power outlet was desired, the wiring could run directly into the junction box through a tube of protective loom and a ceramic bushing. Wiring devices such as light switches, receptacle outlets, and lamp sockets were either surface-mounted, suspended, or flush-mounted within walls and ceilings.