enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [ 2 ] [ 3 ] ,the 37° JIC flare, and the 37° AN flare.

3. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools, commonly referred to as Harbor Freight, is an American privately held tool and equipment retailer, headquartered in Calabasas, California. It operates a chain of retail stores, as well as an e-commerce business.

4. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right. JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface.

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A specialized flaring tool is used to enlarge tubing into a 45º tapered bell shape matching the projecting shape of the flare fitting. [21]: 82 The flare nut, which had previously been installed over the tubing, is then tightened over the fitting to force the tapered surfaces tightly together. Flare connectors are typically brass or plastic ...

6. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

7. Swaging - Wikipedia

   en.wikipedia.org/wiki/Swaging

   Swaging is the generic term for setting a lockbolt and collar assembly. During the installation cycle of a lockbolt, the collar is deformed around the pin with locking grooves using special tooling. The tool engages onto the pintail, which is an extra portion of pin material protruding past the collar that the tool grabs and pulls.