Search results
Results from the WOW.Com Content Network
It is analogous to pulse-width modulation (PWM), in which the magnitude of an analog signal is encoded in the duty cycle of a square wave. Unlike PWM, in which the width of square pulses is varied at a constant frequency, PFM fixes the width of square pulses while varying the frequency.
PWM is useful for controlling the average power or amplitude delivered by an electrical signal. The average value of voltage (and current) fed to the load is controlled by switching the supply between 0 and 100% at a rate faster than it takes the load to change significantly. The longer the switch is on, the higher the total power supplied to ...
An example op-amp circuit drawn with Klunky and GIMP. Klunky can be used to draw basic circuits, and then a raster editing program like GIMP to modify the screenshots. The Klunky program is public domain, and he has enhanced it with additional components, etc. (See User:Omegatron#Electronics_diagrams. Enhanced version is here.
Fig. 2. EMI noise of output voltage for programmed switching frequency (PWM): a) Spectrum and b) Spectrogram. PWM is considered the most common deterministic technique. Considering the example of a DC-DC converter, a controlled switch is designed to “cut-off” the DC waveform into a pulse-shaped waveform.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
This circuit is called a leading-edge dimmer or forward phase dimming. Waveform of the output voltage of a thyristor dimmer set for 60 volts RMS output, with 120 V input. The red trace shows the output device switching on about 5.5 ms after the input (blue) voltage crosses zero.
The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.
Space vector modulation (SVM) is an algorithm for the control of pulse-width modulation (PWM), invented by Gerhard Pfaff, Alois Weschta, and Albert Wick in 1982. [1] [2] It is used for the creation of alternating current (AC) waveforms; most commonly to drive 3 phase AC powered motors at varying speeds from DC using multiple class-D amplifiers.