Ad
related to: decimal to fraction 1 16 6 x 48 veneer scale sheet
Search results
Results from the WOW.Com Content Network
So for a vernier with a constant of 0.1, each mark on the vernier is spaced 9/10 of those on the main scale. If you put the two scales together with zero points aligned, the first mark on the vernier scale is 1/10 short of the first main scale mark, the second is 2/10 short, and so on up to the ninth mark, which is misaligned by 9/10.
The scale can be expressed in four ways: in words (a lexical scale), as a ratio, as a fraction and as a graphical (bar) scale. Thus on an architect's drawing one might read 'one centimeter to one meter', 1:100, 1/100, or 1 / 100 . A bar scale would also normally appear on the drawing.
Using 32 mm (1.26 in) - 0 gauge - track, there is an extensive range of 16 mm to the foot scale [1:19] live-steam and other types of locomotives, rolling stock and accessories. Many of these models are dual gauge, and can be converted to run on 45 mm ( 1.772 in ) track ( gauge 1 ), and radio control is common.
The rather uncommon [citation needed] 40 mm figure scale wargames figures fit approximately into this scale. 1:45: 6.773 mm This is the scale which MOROP has defined for O scale, because it is half the size of the 1:22.5 Scale G-gauge model railways made by German manufacturers. [citation needed] 1:43.5: 7.02 mm: Model railways (0)
Old decimal balance scale A drawing to illustrate a design with two-point support of the platform. A decimal balance or decimal scale is a balance scale which uses the lever in which the arm for weights is 10 times longer than the arm for weighted objects, so that much lighter weights may be used to weigh heavy object. [1]
For example, one inch measured from a drawing with a scale of "one-inch-to-the-foot" is equivalent to one foot in the real world (a scale of 1:12)....one inch measured from a drawing with a scale of "two-inches-to-the-foot" is equivalent to six inches in the real world (a scale of 1:6). It is not to be confused with a true unitless ratio.
For example, a hatch measures 1" wide on the draft. You are building in 3/16" scale. Measuring the hatch in metric, you measure 25 mm. T he conversion factor for 1/4" to 3/16', according to the conversion table is .75. So 25 mm x .75 = 18.75 mm, or about 19 mm. That is the hatch size in 3/16" scale.
The thicknesses vary first by 1 ⁄ 32 inch in higher thicknesses and then step down to increments of 1 ⁄ 64 inch, then 1 ⁄ 128 inch, with the final increments at decimal fractions of 1 ⁄ 64 inch.
Ad
related to: decimal to fraction 1 16 6 x 48 veneer scale sheet