enow.com Web Search

  1. Ads

    related to: 90 degree fixing clamps for metal

Search results

  1. Results from the WOW.Com Content Network
  2. Angle bracket (fastener) - Wikipedia

    en.wikipedia.org/wiki/Angle_bracket_(fastener)

    An angle bracket or angle brace or angle cleat is an L-shaped fastener used to join two parts generally at a 90-degree angle. It is typically made of metal but it can also be made of wood or plastic. Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall.

  3. Clamp holder - Wikipedia

    en.wikipedia.org/wiki/Clamp_holder

    A clamp holder or clamp fastener is a piece of laboratory apparatus that is used to secure laboratory clamps, such as extension-type utility clamps, or other attachments to a retort stand or lab frame. [1] The material can be made up of brass, cast iron, stainless steel, aluminium or nickel-plated zinc. [2]

  4. Hirth joint - Wikipedia

    en.wikipedia.org/wiki/Hirth_joint

    Profile angles of 60 and 90 degrees are used. A key feature of the Hirth joint is that, unlike simple splines, the load-bearing faces of the joint are tapered. This allows the joint to be tightened so that there is no backlash by simply applying an axial load. This is done by either bolting the shafts together or by applying spring pressure ...

  5. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 21 ] : 149 [ 18 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

  6. Street elbow - Wikipedia

    en.wikipedia.org/wiki/Street_elbow

    Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

  7. Universal joint - Wikipedia

    en.wikipedia.org/wiki/Universal_joint

    Edmund Morewood's 1844 patent for a metal coating machine called for a universal joint, by that name, to accommodate small alignment errors between the engine and rolling mill shafts. [14] Ephriam Shay's locomotive patent of 1881, for example, used double universal joints in the locomotive's drive shaft . [ 15 ]

  8. Bolted joint - Wikipedia

    en.wikipedia.org/wiki/Bolted_joint

    The preferred bolt preload for structural applications should be at least 75% of the fastener's proof load [7] for the higher strength fasteners and as high as 90% of the proof load for permanent fasteners. To achieve the benefits of the preloading, the clamping force must be higher than the joint separation load.

  9. Pipe clamp - Wikipedia

    en.wikipedia.org/wiki/Pipe_clamp

    A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.

  1. Ads

    related to: 90 degree fixing clamps for metal