Search results
Results from the WOW.Com Content Network
Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots 1 knot = 1.151 statute mile/h = 0.514 m/s 1 statute mile/h = 0.869 knots = 0.447 m/s. Note: 1 statute mile = 5,280 feet = 1,609 meters
This article presents methods for converting concentrations from ppmv to mg/m 3 (and vice versa) and for correcting the concentrations to the required reference conditions. All of the concentrations and concentration corrections in this article apply only to air and other gases. They are not applicable for liquids.
At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
The amount of pollutant present in air is usually expressed as a concentration, measured in either parts-per notation (usually parts per billion, ppb, or parts per million, ppm, also known as the volume mixing ratio), or micrograms per cubic meter (μg/m³).
Criteria can be set in different units (e.g. μg/m 3, parts per billion by volume (ppbv), parts per billion by mass (ppb (mass)), parts per million (ppm)) and it is possible to convert between all of these units if the molecular mass of the pollutant and the temperature are known. Different standard temperatures are used throughout the world ...
[14] [15] Otherwise, water hardness is measured in the dimensionless unit of parts per million (ppm), numerically equivalent to concentration measured in milligrams per litre. [14] [15] One grain per U.S. gallon is approximately 17.1 ppm. [14] [note 1] Soft water contains 1–4 gpg of calcium carbonate equivalents, while hard water contains 11 ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Molar concentration or molarity is most commonly expressed in units of moles of solute per litre of solution. [1] For use in broader applications, it is defined as amount of substance of solute per unit volume of solution, or per unit volume available to the species, represented by lowercase : [2]