enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   Calling that shield a shell (or D-shell) can be ambiguous, as the term shell is also short for the cable shell, or backshell. D-sub connectors have gender: parts with pin contacts are called male connectors or plugs, while those with socket contacts are called female connectors or sockets. The socket's shield fits tightly inside the plug's shield.

3. VGA connector - Wikipedia

   en.wikipedia.org/wiki/VGA_connector

   In the male connector, this pin numbering corresponds with the cable's wire-and-solder side. The Video Graphics Array ( VGA ) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors ...

4. Attachment Unit Interface - Wikipedia

   en.wikipedia.org/wiki/Attachment_Unit_Interface

   An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.

5. Gender changer - Wikipedia

   en.wikipedia.org/wiki/Gender_changer

   A gender changer is a hardware device placed between two cable connectors of the same type and gender. An example is a cable connector shell with either two female or two male connectors on it (male-to-male or female-to-female), used to correct the mismatches that result when interconnecting two devices or cables with the same gender of connector.

6. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

7. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Bullet terminals, male and female (right-center, with blue wires) A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and ...