Search results
Results from the WOW.Com Content Network
A schematic diagram of the Ebers-Moll models of a PNP BJT. The base, collector and emitter currents are I B, I C and I E, the common-base forward and reverse current gains are α F and α R, and the collector and emitter diode currents are I CD and I ED. Date: 4 August 2010, 05:26 (UTC) Source: Ebers-Moll_Model_PNP.PNG; Author
In a diode model two diodes are connected back-to-back to make a PNP or NPN bipolar junction transistor (BJT) equivalent. This model is theoretical and qualitative. This model is theoretical and qualitative.
PNP transistor symbol with case (IEEE 315). Note: A little confusing on the BJT page, because the NPN is drawn with Collector (C) on the top, while here it is drawn on the bottom. Date: 11 November 2007: Source: Own work: Author: Zedh: Other versions.svg:
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...
Figure 3: PNP version of the emitter-follower circuit, all polarities are reversed. A small voltage change on the input terminal will be replicated at the output (depending slightly on the transistor's gain and the value of the load resistance; see gain formula below). This circuit is useful because it has a large input impedance
An IGBT cell is constructed similarly to an n-channel vertical-construction power MOSFET, except the n+ drain is replaced with a p+ collector layer, thus forming a vertical PNP bipolar junction transistor. This additional p+ region creates a cascade connection of a PNP bipolar junction transistor with the surface n-channel MOSFET. The whole ...
The diagram shows a schematic representation of an NPN transistor connected to two voltage sources. (The same description applies to a PNP transistor with reversed directions of current flow and applied voltage.) This applied voltage causes the lower p–n junction to become forward biased, allowing a flow of electrons from the emitter into the ...
The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail, so the collector outputs a high voltage when the transistor is on or ...