Search results
Results from the WOW.Com Content Network
The first memory location the CPU tries to execute is known as the reset vector. In the case of a hard reboot, the northbridge will direct a code fetch request to the BIOS located on the system flash memory. For a warm boot, the BIOS will be located in the proper place in RAM and the northbridge will direct the reset vector call to the RAM. In ...
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...
Double boot (also known as cold double boot, double cold boot, double POST, power-on auto reboot, or fake boot) is a feature of the BIOS, and may occur after changes to the BIOS' settings or the system's configuration, or a power failure while the system was in one of certain sleep modes.
When debugging a concurrent and distributed system of systems, a bootloop (also written boot loop or boot-loop) is a diagnostic condition of an erroneous state that occurs on computing devices; when those devices repeatedly fail to complete the booting process and restart before a boot sequence is finished, a restart might prevent a user from ...
In computing, the reset vector is the default location a central processing unit will go to find the first instruction it will execute after a reset. The reset vector is a pointer or address , where the CPU should always begin as soon as it is able to execute instructions.
When Secure Boot is enabled, it is initially placed in "setup" mode, which allows a public key known as the "platform key" (PK) to be written to the firmware. Once the key is written, Secure Boot enters "User" mode, where only UEFI drivers and OS boot loaders signed with the platform key can be loaded by the firmware.
A Samsung Nuon N2000 television and DVD remote control An air conditioning unit remote control. In electronics, a remote control (also known as a remote or clicker [1]) is an electronic device used to operate another device from a distance, usually wirelessly.
An initramfs-style boot is similar, but not identical to the described initrd boot. At this point, with interrupts enabled, the scheduler can take control of the overall management of the system, to provide pre-emptive multi-tasking, and the init process is left to continue booting the user environment in user space.