Search results
Results from the WOW.Com Content Network
A rotary reciprocating saw is a type of saw that spins a cutting implement around a rotary axis, instead of thrusting it along a linear axis. The first use of such devices was in medicine , where cutting through bone warranted the need for a saw with minimal stroke length, and a cutting action that could be implemented through depth cut rather ...
With all in-line slider-crank mechanisms, the stroke is twice the length of the crank arm. Therefore, given the stroke, the length of the crank arm can be determined. This relationship is represented as: L 2 = (ΔR 4) max ÷ 2. Once L 2 is found, the follower length (L 3) can be determined. However, because the stroke of the mechanism only ...
Rotary reciprocating saw – Type of mechanical saw; Agitation – Device or mechanism which shakes or stirs something; Scotch yoke – Mechanism to convert between rotational and reciprocating motion; Crank – Simple machine transferring motion to or from a rotating shaft at a distance from the centreline; Crankshaft – Mechanism for ...
An engine is described as oversquare or short-stroke if its cylinders have a greater bore diameter than its stroke length, giving a bore/stroke ratio greater than 1:1. An oversquare engine allows for more and larger valves in the head of the cylinder, higher possible rpm by lowering maximum piston speed, and lower crank stress due to the lower ...
Note that for the automotive/hotrod use-case the most convenient (used by enthusiasts) unit of length for the piston-rod-crank geometry is the inch, with typical dimensions being 6" (inch) rod length and 2" (inch) crank radius. This article uses units of inch (") for position, velocity and acceleration, as shown in the graphs above.
A reciprocating saw is a type of handheld, small, machine-powered saw, in which the cutting action is achieved through a push-and-pull ("reciprocating") or back-and-forth motion of the blade. The original trade name, Sawzall , is often used in the United States , where Milwaukee Electric Tool first produced a tool of this type in 1951.
The bore/stroke ratio is the ratio of the diameter of the piston, or "bore", to the length of travel within the cylinder, or "stroke". If this is around 1 the engine is said to be "square". If it is greater than 1, i.e. the bore is larger than the stroke, it is "oversquare".
The induction stroke is the first phase in a four-stroke (e.g. Otto cycle or Diesel cycle) engine.It involves the downward movement of the piston, creating a partial vacuum that draws an air-fuel mixture (or air alone, in the case of a direct injection engine) into the combustion chamber.