Search results
Results from the WOW.Com Content Network
Generally, forced convection heat sink thermal performance is improved by increasing the thermal conductivity of the heat sink materials, increasing the surface area (usually by adding extended surfaces, such as fins or foam metal) and by increasing the overall area heat transfer coefficient (usually by increase fluid velocity, such as adding ...
Socket 370, also known as PGA370, is a CPU socket first used by Intel for Pentium III and Celeron processors to first complement and later replace the older Slot 1 CPU interface on personal computers. The "370" refers to the number of pin holes in the socket for CPU pins. Socket 370 was replaced by Socket 423 in 2000.
Rca (°C/W) = Thermal resistance of the Heat sink, between the case of the CPU and the ambient air. Tc = Maximum allowed temperature of the CPU's case (ensuring full performances). Ta = Maximum expected ambient temperature at the inlet of the Heat sink fan. All these parameters are linked together by the following equation:
A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan. Vertical aluminium ...
A heat sink is not a device with the "magical ability to absorb heat like a sponge and send it off to a parallel universe". [2] Natural convection requires free flow of air over the heat sink. If fins are not aligned vertically, or if fins are too close together to allow sufficient air flow between them, the efficiency of the heat sink will ...
A CPU shim. A CPU shim (also called CPU spacer) is a shim used between the CPU and the heat sink in a computer. Shims make it easier and less risky to mount a heatsink on the processor because it stabilizes the heatsink, preventing accidental damaging of the fragile CPU packaging. [1] They help distribute weight evenly over the surface.
Fans attached to components are usually used in combination with a heat sink to increase the area of heated surface in contact with the air, thereby improving the efficiency of cooling. Fan control is not always an automatic process. A computer's BIOS can control the speed of the built-in fan system for the computer. A user can even supplement ...
The Mollier enthalpy–entropy diagram for water and steam. The "dryness fraction", x , gives the fraction by mass of gaseous water in the wet region, the remainder being droplets of liquid. An enthalpy–entropy chart , also known as the H – S chart or Mollier diagram , plots the total heat against entropy, [ 1 ] describing the enthalpy of a ...