enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Three-prong adaptor - Wikipedia

   en.wikipedia.org/wiki/Three-prong_adaptor

   When used as intended, the ground pin of the 3-wire receptacle is to be connected to a grounded cover screw, or to an external ground. In 1969, Underwriters Laboratories mandated three-prong plugs on major appliances for safety. [7] At that time, only half of the receptacles in US homes were three-prong. [7]

3. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   As an example, the 5-15R is the common 125 V two-pole, three-wire receptacle rated for 15 A. The L5-15R, while sharing the same electrical rating, is a locking design that is not physically compatible with the straight-blade 5-15 design. The 5-30R has the same two-pole, three-wire configuration and 125 V rating, but is rated for 30 A.

4. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   IEC 60309 (formerly IEC 309 and CEE 17, also published by CENELEC as EN 60309) is a series of international standards from the International Electrotechnical Commission (IEC) for "plugs, socket-outlets and couplers for industrial purposes".

5. AC power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets

   BS 546, "Two-pole and earthing-pin plugs, socket-outlets and socket-outlet adaptors for AC (50-60 Hz) circuits up to 250 V" describes four sizes of plug rated at 2 A, 5 A (Type D), 15 A (Type M) and 30 A.

6. Industrial and multiphase power plugs and sockets - Wikipedia

   en.wikipedia.org/wiki/Industrial_and_multiphase...

   The type 15 plug and socket has 3 round pins of 4 mm diameter, plus 2 flat pins (for L2 and L3). It is designed for three phase applications and is rated at 10 A, 250 V/440 V. The socket will also accept types 11 and 12 plugs, and the Europlug. The type 25 plug and socket has 3 rectangular pins, 4 mm x 5 mm, plus 2 flat pins (for L2 and L3).

7. Electrical outlet tester - Wikipedia

   en.wikipedia.org/wiki/Electrical_outlet_tester

   A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...

8. Residents full of questions for Home Depot - AOL

   www.aol.com/residents-full-questions-home-depot...

   Nov. 4—Moscow residents pressed Home Depot officials on matters like traffic, jobs and water use during a community meeting Friday in Moscow. In August, the Idaho State Board of Education ...

9. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...