enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Concrete degradation - Wikipedia

   en.wikipedia.org/wiki/Concrete_degradation

   The filling of cracks, fissures or voids in concrete for structural purposes (restoration of strength and load-bearing capability), or non-structural reasons (flexible repairs where further movement is expected, or alternately to resist water and gas permeation) typically involves the injection of low viscosity resins or grouts based on epoxy ...

3. Concrete pavement restoration - Wikipedia

   en.wikipedia.org/wiki/Concrete_Pavement_Restoration

   Dowel bar retrofit (DBR) is a process that re-establishes load transfer capability on joints and cracks by installing epoxy-coated, round steel dowels into existing concrete pavement across transverse joints and/or cracks. Slots are cut using diamond-tipped saw blades; the existing concrete is removed and the dowels are placed in the slots ...

4. Concrete sealer - Wikipedia

   en.wikipedia.org/wiki/Concrete_sealer

   They require a dry, clean surface during application to gain adhesion. Topical sealers may alter the coefficient of friction which can make substrates slick when wet – a condition that can be remedied by adding anti-skid materials. Life span is generally 1-5 years, although high-end epoxy/urethane systems can last significantly longer.

5. Damp proofing - Wikipedia

   en.wikipedia.org/wiki/Damp_proofing

   Integral damp proofing in concrete involves adding materials to the concrete mix to make the concrete itself impermeable. [ 4 ] Surface suppressant coating with thin water proof materials such as epoxy resin for resistance to non-pressurized moisture such as rain water or a coating of cement sprayed on such as shotcrete which can resist water ...

6. Polymer concrete - Wikipedia

   en.wikipedia.org/wiki/Polymer_concrete

   Polymer concrete is a type of concrete that uses a polymer to replace lime-type cements as a binder. One specific type is epoxy granite , where the polymer used is exclusively epoxy . In some cases the polymer is used in addition to portland cement to form Polymer Cement Concrete (PCC) or Polymer Modified Concrete (PMC). [ 1 ]

7. Damp (structural) - Wikipedia

   en.wikipedia.org/wiki/Damp_(structural)

   Injection systems were typically injected at an application rate of approximately 100g of active ingredient per linear metre of 275 mm (9 inch) thick wall. However, because the strength of cream formulations used in the UK can vary widely, the applied amount of delivered active material varied from 22g to 107g per linear metre depending on ...