Ads
related to: 2 rigid 90 degree elbowsupplyhouse.com has been visited by 100K+ users in the past month
- 100 South Grener Rd, Columbus, OH · Directions · (614) 878-9150
ebay.com has been visited by 1M+ users in the past month
zoro.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
This naming convention applies to other plumbing elbows, such as: - "88 degree elbow" = 92 degrees on a protractor. Visualise bending the left end of the pipe up 88 degrees. Now turn the piece of pipe around so the horizontal piece of pipe is in line with the zero degrees line on the protractor. The protractor will read 92 degrees.
Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.
Threaded pipe and elbow.The pipe has a male NPT thread, while the elbow is female.. American National Standard Pipe Thread standards, often called national pipe thread standards for short, are United States national technical standards for screw threads used on threaded pipes and pipe fittings.
JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.
In addition to providing access to wires for pulling, "L" fittings allow a 90 degree turn in conduit where there is insufficient space for a full-radius 90 degree sweep (curved conduit section). T-shaped bodies ("Tees") feature an inlet in line with the access cover and outlets to both the cover's left and right.
AN fittings are a flare fitting, using 37° flared tubing to form a metal-to-metal seal. They are similar to other 37° flared fittings, such as JIC , which is their industrial variant. [ 2 ] The two are interchangeable in theory, though this is typically not recommended due to the exacting specifications and demands of the aerospace industry.
Ads
related to: 2 rigid 90 degree elbowsupplyhouse.com has been visited by 100K+ users in the past month
- 100 South Grener Rd, Columbus, OH · Directions · (614) 878-9150
ebay.com has been visited by 1M+ users in the past month
zoro.com has been visited by 100K+ users in the past month