Search results
Results from the WOW.Com Content Network
The first Ford Model T used carbide lamps for headlights and oil lamps for tail lights. It did not have all-electric lighting as a standard feature until several years after its introduction. Dynamos for automobile headlights were first fitted around 1908 and became commonplace in 1920s automobiles.
The Twilight Sentinel system uses a photoelectric cell to measure ambient light levels. This cell is typically mounted on the dashboard of the vehicle. [7] The system is designed to activate the vehicle's exterior lights when the ambient light falls below a certain threshold, typically corresponding to twilight conditions.
By means of a light intensity sensor ( photoresistor, photodiode, phototransistor, etc.) that detects the amount of light that illuminates an environment, it triggers an electrical circuit that opens or closes the contacts of a mechanical relay or of a solid state relay. (power transistor, thyristor, triac, etc.), which activates the lighting ...
Engine bay lighting; Fog light (also called foglamp) Spotlight; Headlight (also called headlamp) Headlight motor; Interior light and lamp, Center dome, Vanity-Sun visor and rear side, Floor and Door-front, back, Boot lamp or Trunk lamp; License plate lamp (also called number plate lamp or registration plate lamp) Side lighting
Attitude control (spacecraft): Horizon sensor, Earth sensor, Moon sensor, Satellite Sensor, Sun sensor; Catadioptric sensor; Chemoreceptor; Compressive sensing; Cryogenic particle detectors; Dew warning; Diffusion tensor imaging; Digital holography; Electronic tongue; Fine Guidance Sensor; Flat panel detector; Functional magnetic resonance ...
In order to show compliance to FMVSS 108, the lens of each original equipment and replacement headlamp, daytime running lamp (DRL) and certain conspicuity reflectors must be marked with the symbol "DOT". [1]: S6.5, S8.2.1.3, Table III This symbol may also be applied to compliant signal lighting devices, but is not mandatory.
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
Full-voltage vs. parking light headlamp on European-market Volkswagen, 2007. Depending on prevailing regulations and equipment, vehicles may implement the daytime-running light function by functionally turning on specific lamps, by operating low-beam headlamps or fog lamps at full or reduced intensity, by operating high-beam headlamps at reduced intensity, or by steady-burning operation of the ...