enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drive shaft - Wikipedia

   en.wikipedia.org/wiki/Drive_shaft

   A drive shaft, driveshaft, driving shaft, tailshaft (Australian English), propeller shaft (prop shaft), or Cardan shaft (after Girolamo Cardano) is a component for transmitting mechanical power, torque, and rotation, usually used to connect other components of a drivetrain that cannot be connected directly because of distance or the need to ...

3. Spline (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Spline_(mechanical)

   Drive shafts on vehicles and power take-offs use splines to transmit torque and rotation and allow for changes in length. Splines are ubiquitous in aerospace, due to the spline's higher reliability and fatigue life compared to keyed shafts.

4. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   The following stresses are induced in the shafts.. Shear stresses due to the transmission of torque (due to torsional load).; Bending stresses (tensile or compressive) due to the forces acting upon the machine elements like gears and pulleys as well as the self weight of the shaft.

5. Universal joint - Wikipedia

   en.wikipedia.org/wiki/Universal_joint

   Universal joints in a driveshaft. A configuration known as a double Cardan joint drive shaft partially overcomes the problem of jerky rotation. This configuration uses two U-joints joined by an intermediate shaft, with the second U-joint phased in relation to the first U-joint to cancel the changing angular velocity.

6. Length measurement - Wikipedia

   en.wikipedia.org/wiki/Length_measurement

   Length measurement, distance measurement, or range measurement (ranging) all refer to the many ways in which length, distance, or range can be measured. The most commonly used approaches are the rulers, followed by transit-time methods and the interferometer methods based upon the speed of light .

7. Constant-velocity joint - Wikipedia

   en.wikipedia.org/wiki/Constant-velocity_joint

   A Rzeppa-type CV joint. A constant-velocity joint (also called a CV joint and homokinetic joint) is a mechanical coupling which allows the shafts to rotate freely (without an appreciable increase in friction or backlash) and compensates for the angle between the two shafts, within a certain range, to maintain the same velocity.