Search results
Results from the WOW.Com Content Network
An example of use is mounting of car rims, where the bolt circle is one of several factors that determine whether a set of rims will fit a car. For example, a bolt circle of 5×130 or 5-130 indicates that a rim is to be attached to the car via 5 screws evenly spaced along a circle with a diameter of 130 millimeters. [1]
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.
The length of a machine screw or bolt is indicated by an × and the length expressed in millimetres (e.g. M8-1.25×30 or M8×30). [citation needed] Tolerance classes defined in ISO 965-1 can be appended to these designations, if required (e.g. M500– 6g in external threads). External threads are designated by lowercase letter, g or h.
A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...
Highly decorative wood-shingle siding on a house in Clatskanie, Oregon, U.S. Siding or wall cladding is the protective material attached to the exterior side of a wall of a house or other building. Along with the roof, it forms the first line of defense against the elements, most importantly sun, rain/snow, heat and cold, thus creating a stable ...
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
A countersink is a conical hole cut into a manufactured object; a countersink bit (sometimes called simply countersink) is the cutter used to cut such a hole. A common use is to allow the head of a bolt or screw, with a shape exactly matching the countersunk hole, to sit flush with or below the surface of the surrounding material.
A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .