Search results
Results from the WOW.Com Content Network
The difference in names between the two systems is due to the opening up of the monomer's double bond upon polymerization. [48] The name is abbreviated to PE . In a similar manner polypropylene and polystyrene are shortened to PP and PS, respectively.
The density of PP is between 0.895 and 0.93 g/cm 3. Therefore, PP is the commodity plastic with the lowest density. With lower density, moldings parts with lower weight and more parts of a certain mass of plastic can be produced. Unlike polyethylene, crystalline and amorphous regions differ only slightly in their density.
The PP and PE components of a blend constitute the "crystalline phase", and the rubber and branched PE chains and PE/PP end groups gives the "amorphous phase". If PP and PE are the dominant component of a TPO blend then the rubber fraction will be dispersed into a continuous matrix of "crystalline" polypropylene.
Recycling codes on products. Recycling codes are used to identify the materials out of which the item is made, to facilitate easier recycling process.The presence on an item of a recycling code, a chasing arrows logo, or a resin code, is not an automatic indicator that a material is recyclable; it is an explanation of what the item is made of.
An alpha-olefin (or α-olefin) is an alkene where the carbon-carbon double bond starts at the α-carbon atom, i.e. the double bond is between the #1 and #2 carbons in the molecule. Alpha-olefins such as 1-hexene may be used as co-monomers to give an alkyl branched polymer (see chemical structure below), although 1-decene is most commonly used ...
The spacing between domains has been confirmed by small-angle X-ray scattering, a technique which gives information about microstructure. Since most polymers are incompatible with one another, forming a block polymer will usually result in phase separation, and the principle has been widely exploited since the introduction of the SBS block ...
The difference between "PE" and BDC Business development companies, like Blackstone and Fortress, are private equity investors. However, they differ in that their shareholders are rewarded ...
An ABS 3D bell manufactured with a 3D printer. Engineering plastics [1] are a group of plastic materials that have better mechanical or thermal properties than the more widely used commodity plastics (such as polystyrene, polyvinyl chloride, polypropylene and polyethylene).