enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fuse (electrical) - Wikipedia

   en.wikipedia.org/wiki/Fuse_(electrical)

   A time-delay fuse (also known as an anti-surge or slow-blow fuse) is designed to allow a current which is above the rated value of the fuse to flow for a short period of time without the fuse blowing. These types of fuse are used on equipment such as motors, which can draw larger than normal currents for up to several seconds while coming up to ...

3. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   In the United Kingdom and in Ireland, this system is usually referred to simply as a "13 amp plug" or a "13 amp socket". BS 546 , Two-pole and earthing-pin plugs, socket-outlets and socket-outlet adaptors for AC (50–60 Hz) circuits up to 250 V is an older British Standard for three-pin AC power plugs and sockets .

4. Ampere - Wikipedia

   en.wikipedia.org/wiki/Ampere

   The 2019 revision of the SI defined the ampere by taking the fixed numerical value of the elementary charge e to be 1.602 176 634 × 10 −19 when expressed in the unit C, which is equal to A⋅s, where the second is defined in terms of ∆ν Cs, the unperturbed ground state hyperfine transition frequency of the caesium-133 atom.

5. Breaking capacity - Wikipedia

   en.wikipedia.org/wiki/Breaking_capacity

   Breaking capacity or interrupting rating [1] [2] is the current that a fuse, circuit breaker, or other electrical apparatus is able to interrupt without being destroyed or causing an electric arc with unacceptable duration.

6. Volt-ampere - Wikipedia

   en.wikipedia.org/wiki/Volt-ampere

   In direct current (DC) circuits, this product is equal to the real power, measured in watts. [3] The volt-ampere is dimensionally equivalent to the watt: in SI units, 1 V⋅A = 1 W. VA rating is most used for generators and transformers, and other power handling equipment, where loads may be reactive (inductive or capacitive).

7. Per-unit system - Wikipedia

   en.wikipedia.org/wiki/Per-unit_system

   The base value should only be a magnitude, while the per-unit value is a phasor. The phase angles of complex power, voltage, current, impedance, etc., are not affected by the conversion to per unit values. The purpose of using a per-unit system is to simplify conversion between different transformers.

8. Conversion of units - Wikipedia

   en.wikipedia.org/wiki/Conversion_of_units

   The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...

9. Ohm's law - Wikipedia

   en.wikipedia.org/wiki/Ohm's_law

   Ohm's law states that the electric current through a conductor between two points is directly proportional to the voltage across the two points. Introducing the constant of proportionality, the resistance, [1] one arrives at the three mathematical equations used to describe this relationship: [2]