enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Limited-slip differential - Wikipedia

   en.wikipedia.org/wiki/Limited-slip_differential

   The spider gears mount on the pinion cross shaft which rests in angled cutouts forming cammed ramps. The cammed ramps are not necessarily symmetrical. If the ramps are symmetrical, the LSD is 2 way. If they are saw toothed (i.e. one side of the ramp is vertical), the LSD is 1 way. If both sides are sloped, but are asymmetric, the LSD is 1.5 way.

3. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   The left sun gear (red) provides more resistance than the right sun gear (yellow), which causes the planet gear (green) to rotate anti-clockwise. This produces slower rotation in the left sun gear and faster rotation in the right sun gear, resulting in the car's right wheel turning faster (and thus travelling farther) than the left wheel.

4. Axle - Wikipedia

   en.wikipedia.org/wiki/Axle

   A true semi-floating axle assembly places no side loads on the axle housing tubes or axle shafts. Axles that are pressed into ball or tapered roller bearings, which are in turn retained in the axle housings with flanges, bolts, and nuts do not "float" and place axial loads on the bearings, housings, and only a short section of the shaft itself ...

5. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   A variation of the Dana 60 known as a Dana 61 was made to accommodate gear ratios that allowed for better fuel mileage. This was done as a direct result of the 1973 oil crisis. A 3.07:1 gear ratio was common for these axles and unachievable in a regular Dana 60. To allow for the different gearing, the Dana 61 had a greater pinion offset.

6. Locking differential - Wikipedia

   en.wikipedia.org/wiki/Locking_differential

   A spool or full spool (in contrast to mini-spool) is a device that connects the two axles directly to the ring gear. There is no differentiation side to side, so a vehicle equipped with a spool will bark tires in turns and may become unmanageable in wet or snowy weather. Spools are usually reserved for competition vehicles not driven on the street.

7. Spiral bevel gear - Wikipedia

   en.wikipedia.org/wiki/Spiral_bevel_gear

   The shape of a hypoid gear is a revolved hyperboloid (that is, the pitch surface of the hypoid gear is a hyperbolic surface), whereas the shape of a spiral bevel gear is normally conical. The hypoid gear places the pinion off-axis to the crown wheel (ring gear) which allows the pinion to be larger in diameter and have more contact area. In ...

8. AOL Mail

   mail.aol.com/d?reason=invalid_cred

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Reduction drive - Wikipedia

   en.wikipedia.org/wiki/Reduction_drive

   The gear manufacturer is then responsible for ensuring basic gear alignment, such that the final assembly measurements are taken carefully and recorded for the reduction drive to be installed correctly, proper tooth contact in the factory, where the manufacturer accurately and precisely assembles the gears and pinions, and denoting all steps ...