Search results
Results from the WOW.Com Content Network
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB, is defined by [1]
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu). Examples. 100 dBμ or 100 mV/m: blanketing interference may occur on some receivers
Practically, this means that, armed only with the knowledge that 1 dB is a power gain of approximately 26%, 3 dB is approximately 2× power gain, and 10 dB is 10× power gain, it is possible to determine the power ratio of a system from the gain in dB with only simple addition and multiplication. For example:
This corresponds to the following non-logarithmic gain model: =, where = / is the average multiplicative gain at the reference distance from the transmitter. This gain depends on factors such as carrier frequency, antenna heights and antenna gain, for example due to directional antennas; and = / is a stochastic process that reflects flat fading.
In the bipolar transistor example, it is the ratio of the output current to the input current, both measured in amperes. In the case of other devices, the gain will have a value in SI units. Such is the case with the operational transconductance amplifier , which has an open-loop gain ( transconductance ) in siemens ( mhos ), because the gain ...
A front-to-back ratio is usually expressed in decibels (dB). In point-to-point microwave antennas, a "high performance" antenna usually has a higher front to back ratio than other antennas. For example, an unshrouded 38 GHz microwave dish may have a front to back ratio of 64 dB, while the same size reflector equipped with a shroud would have a ...
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum peak level. The unit is similar to the units dBov and decibels relative to overload ( dBO ).