Search results
Results from the WOW.Com Content Network
An SS7 point code is an address for the SS7 telephone switching system. It is similar to an IP address in an IP network. It is a unique address for a node (Signaling Point, or SP), used in MTP layer 3 to identify the destination of a message signal unit (MSU).
Signalling System No. 7 (SS7) is a set of telephony signaling protocols developed in the 1970s that is used to setup and teardown telephone calls on most parts of the global public switched telephone network (PSTN).
The Message Transfer Part (MTP) is part of the Signaling System 7 (SS7) used for communication in Public Switched Telephone Networks. MTP is responsible for reliable, unduplicated and in-sequence transport of SS7 messages between communication partners. MTP is formally defined primarily in ITU-T recommendations Q.701, Q.702, Q.703, Q.704 and Q.705.
The Short Message protocol itself is defined by 3GPP TS 23.040 for the Short Message Service - Point to Point (SMS-PP), [2] and 3GPP TS 23.041 for the Cell Broadcast Service (CBS). [3] Four MAP procedures are defined for the control of the Short Message Service: [1] Mobile Originated (MO) short message service transfer;
A Signal Transfer Point (STP) is a node in an SS7 network that routes signaling messages based on their destination point code in the SS7 network. [1] It works as a router that relays SS7 messages between signaling end-points (SEPs) and other signaling transfer points (STPs).
Answer message (ANM) — Sent when the subscriber picks up the phone, a resource is connected or answer supervision is returned by an interworking point. Normally charging starts at this moment. It is required that the call be cut through in both directions by this point. Connect (CON) — Sent when the call is answered by an automatic terminal.
SCCP employs a process called Global Title Translation to determine Point Codes from Global Titles so as to instruct MTP on where to route messages. SCCP messages contain parameters which describe the type of addressing used, and how the message should be routed: Address Indicator. Routing indicator. Route on Global Title; Route on Point Code ...
An SSP telephone exchange receives a call to an 0800 number. This causes a trigger within the SSP that causes an SCP (Service Control Point) to be queried using SS7 protocols (INAP, TCAP). The SCP responds with a geographic number, e.g. 0121 XXX XXXX, and the call is actually routed to a phone. By this architecture: