Search results
Results from the WOW.Com Content Network
A hydraulic system is required for high speed flight and large aircraft to convert the crews' control system movements to surface movements. The hydraulic system is also used to extend and retract landing gear, operate flaps and slats, operate the wheel brakes and steering systems.
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
English: Landing gear of an aircraft, schematic view of the retracting mechanism. Filled circles are fixed relative to the airframe. Coloured arcs denote the locus of points. 1 Hydraulic Ram 2 Hinge Mechanism 3 Strut 4 Wheel Boss 5 Wheel . 6 Fuselage/Wing
Two aircraft manufacturers produce commercial passenger aircraft with primary flight computers that can perform under different flight control modes. The most well-known is the system of normal , alternate , direct laws and mechanical alternate control laws of the Airbus A320 - A380 . [ 3 ]
In aviation, a power transfer unit (PTU) is a device that transfers hydraulic power from one of an aircraft's hydraulic systems to another in the event that the other system has failed or been turned off. The PTU is used when, for example, there is right hydraulic system pressure but no left hydraulic system pressure.
A series of (e.g. labyrinth) seals allow a small flow of bleed air to wash the turbine disc to extract heat and, at the same time, pressurize the turbine rim seal, to prevent hot gases entering the inner part of the engine. Other types of seals are hydraulic, brush, carbon etc.
Derived from the words hydraulics and pneumatics, pneudraulics is the term used when discussing systems on military aircraft that use either or some combination of hydraulic and pneumatic systems. [1] The science of fluids made of both gas and liquid.