Search results
Results from the WOW.Com Content Network
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT ...
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
A cord is the amount of wood that, when "racked and well stowed" (arranged so pieces are aligned, parallel, touching, and compact), occupies a volume of 128 cubic feet (3.62 m 3). [1] This corresponds to a well-stacked woodpile 4 feet (122 cm) high, 8 feet (244 cm) wide, and 4 feet (122 cm) deep; or any other arrangement of linear measurements ...
In 1950, the United States produced 38 billion board feet of lumber, and that number remained fairly constant throughout the decades moving forward, with the national production at 32.9 billion board feet in 1960 and 34.7 billion board feet in 1970. [61]
The invention of laminated veneer lumber as known today can be attributed to Arthur Troutner. While glue laminated wood veneers were in use since the middle of the 19th century on a small scale for furniture and pianos, Troutner was the first to develop a laminated veneer lumber of a scale large enough to be used in construction.
Finger-jointed lumber – solid dimensional lumber lengths typically are limited to lengths of 22 to 24 feet (6.7–7.3 m), but can be made longer by the technique of "finger-jointing" by using small solid pieces, usually 18 to 24 inches (460–610 mm) long, and joining them together using finger joints and glue to produce lengths that can be ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
While linear elastic behavior is often assumed for Cross-Laminated Timber (CLT), in reality, its performance is not always linear and needs to be studied in a non-linear context. Additionally, the connection between different layers cannot always be fully bonded, and the moisture content of the wood will change over time.